Not quite what I intended

Oh well, that didn’t quite work out as I intended. We went to Snetterton last weekend for the next race in the RGB championship. I was hopeful that the new engine would do something useful, although wary that the bodged around exhaust wasn’t really going to help. Also, the car hadn’t been been on a dyno which wasn’t going to help.

Continue reading “Not quite what I intended”

Startup 08

It’s definitely the finishing straight now, barring some horrific problem. First up is that I finished re-installing the transmission. As a consequence of careful design and planning, cough, it all fitted fine and will hopefully work OK.

Luckily, the gearchange lever on the ’08 engine is in almost exactly the same position as on the ’07 engine so no change was necessary here. You can see my super-long gearchange cable snaking around the engine in the photo here.

Continue reading “Startup 08”

Electrification

So, on with the tale of the engine upgrade.

As a couple of people suggested to me, I made a support for the standard-sump equipped engine as in the photo here. This allowed me to support the engine in position to see what I was going to have to do to make some engine mounts.

Note that I’m using a motor sport magazine to get the support at the right height.

Continue reading “Electrification”

Too slow…

Last weekend was the first of out visits to Snetterton this year. We were running on the 200 circuit which is pretty much the same sort of layout at the original circuit, albeit with the hairpin at Montreal which is huge shame after losing Sear and the left hander at Murray’s which is a replacement for the original Russell chicane. It’s a shame to lose the original Coram corner and, also, Jim Russell’s name from the circuit. The interesting bits of the new circuit are all on the 300 circuit, as I tested on earlier this year.

Continue reading “Too slow…”

White car man

As discussed, I bit the bullet and remade some of the suspension components. First up is the rather short rear upper wishbone, as in the photo. It’s the iridescent white component. (I’ve got fed up using POR-15 which always goes a weird non-grey colour so I’ve decided to start spraying things like with rattle cans. As, oddly, Halfords don’t sell rattle cans for grey cars I settled on white as a decent light colour. Black would be nice but I’m paranoid about being able to see cracks appearing.

Continue reading “White car man”

Onwards and upwards

Yet again, too long since the last update. I’ve just been moving forwards very slowly on many fronts so this is a sort of catching-up post.

I finished the oil cooler duct, as seen in the photo. I hope it’s going to have some  effect, if it doesn’t I’ve got a couple of ideas as to how to persuade more air to do into it. It’s not particularly pretty though.

Continue reading “Onwards and upwards”

Too much to do

Since the last meeting at Brands I’ve had a collection of things to do. You will remember that I said I’d broken my finger in the first race at the weekend. So I did but it’s really rather minor. I did manage to work out a way of continuing to work on the car which involved modifying a pair of work gloves by cutting two of the fingers apart and gaffer taping them together. I was quite pleased with that, although the hospital have now unstrapped my finger and it’s floating free so these fetching gloves are now looking for a new home.

Continue reading “Too much to do”

Spoiling it

It’s getting closer and closer to the first race, although I’ve got one more test before then, but I’m thinking more and more about the race. (That is, I’m getting very nervous!)

So, I’ve just been doing a few bits and pieces really.  First up was fixing a small problem. I found at the recent Snetterton test that when I climbed into the car I tended to whack my knee on the connector on the bottom of the Palm, breaking it! So, I’ve put a little extension on the bottom of the mounting plate to hopefully support it a bit better.

Continue reading “Spoiling it”