OK, I realise there’s a bit of a contrast between the title and that big A over on the right. However, it seemed appropriate as I’ve finally finished all of the wiring.
And, as you can see, the lights work.
Author: Tim Hoverd
Filling in
With loins still firmly girded, bloody uncomfortable I can tell you, I’ve been getting the bodywork properly finished. As discussed I’ve made an aluminium panel to fill in the gap at the back of the seats, as in the photo.
Buses
… supposedly come along in threes. Not sure about that, but it does appear to apply to posts.
With loins girded, I set about getting the bodywork finally sorted. As I said, I took off the hinge that was locating the engine cover (the steel tube at the bottom of the photo) and added a couple of little aluminium supports (just above the steel tube).
Loin girding
Right then. The time has come to actually get this J15 finished. What would be nice is to get the car finished by the end of the year which would give me time to do some testing in the New Year. This picture is the car in its current state, sitting on the drive between the motorhome and the trailer while I used the entire garage for the Fury.
“The time has come,” the Walrus said, “To talk of many things…”
And in particular, “where the heck have you been?”
Well, I’ve been busy. I realise that’s not a good excuse but I really have, honest. I’ve just finished teaching a 4 week long class to a set of Masters students (and writing the exam they have to take) and I’ve been trying to concentrate on getting my thesis written. Problem is, I keep thinking of more things that ought to be in there so I’m actually going backwards on that one.
Continue reading ““The time has come,” the Walrus said, “To talk of many things…””
Putting the fire out
Back in J15 land, things are progressing albeit slowly. I must admit that I’m getting down to the scraping the barrel things here. Of course, as usual there’s lots of these.
One thing to do was to fit the various cable releases. First of all, the electrical one. I favour a good old fashioned cable job so I added an anchor for the cable outer to the side of the switch panel as you can see in the photo. I’ve also twisted the master switch around slightly so that the angle of pull works a bit better.
Out with a whimper
The last races of the season took place at Oulton Park, a great circuit in Cheshire where it always seems to rain. However, this time on the journey there it didn’t rain so much as monsooned, if that’s a noun that can be verbed. That is, it absolutely threw it down. When we got there the car, which is carried on an open trailer, was not so much wet as impersonating a bathtub.
Lagged
So, I needed to fix the Fury. That meant I needed to make a new wishbone and here it is sitting in the jig. The problem was that in thinking about the design of the wishbone then at one point I must have lost my presence of mind.
Broke it again
Another race weekend at Snetterton, with an annoying final result. Oh well… Back to the beginning, though. The schedule was for there to be an RGB race on the Sunday only. However, the club had opened up the Bikesports race to us and, dutifully, a whole stack of us had signed up only for the race to be over-subscribed. That meant that there was now a non-championship RGB race and a championship one. The qualifying for the former was to be run with the Bikesports chaps.
Bleeding progress
A bit more progress to report, again mainly around the J15’s rebuilt braking system. With the new master cylinders I’m going to have to use a different fluid reservoir. In particular, I need to mount the fluid higher up so as to be sure that it’s downhill into the master cylinder.